Drawbar Hitch Ring

Made to weld into a 3" by 3" by 1/4" wall tube.

Price: $99.99

• 3.00" by 3.75" hitch hole
• 1.5" by 1.5" band of steel around the hitch hole (this maximizes chain elevation, it is like you are hooking 1/4" higher)
• This is legal at PPL pulls
• This is made for 2.5" tube to be welded on to this ring (if you want to use 2" tube, we recommend welding 1/4 by 1" by 2.5" flat bar to the inside then for final weld it all together)
• This is setup to weld plates on the side to put bolts in if you want to adjust off the rear (to pass rules it cannot be drilled and tapped in this part, therefor welding 1" by 2" bar on the side is required if you want to adjust off the rear hookpoint)
• Made in USA.
• Pulling Products Drawbar Hitch Ring is designed for competition and off-road recovery applications only, and is not intended for use on public roads.

Money Order:
Send money order to
Jonathan L. Martin
699 Burnt house Road
Carlisle, PA 17015-9264

LIFETIME WARRANTY If you break your drawbar hitch, just send it back and we will replace it at no cost to you.

Legal: Pulling Products Drawbar Hitch is designed for competition and off-road recovery applications only, and is not intended for use on public roads.

Related Products